20C DEFENDER 110/23C DEFENDER 130 SUV RUNNING BOARDS RALB SIDE STEPS BLACK

Turned out to fit real nice on 2025 explorer but there were a few things that were to tight and had to adjust . The rear mount holes were not elongated back enough to the right angle mounted welded plate by 1/4 inch and hit a popped screw mounted to hold under body cover mount and 2 mid and front body brackets were 1/8 inch to wide. A big disappointment was the cheap U clip nuts that needed to be pinch tight to be able to snap into hole and not float as to each moved all over when trying to mount bracket with 2 side bolts in place , a pliers crimping them closed and snapping them in place helped but still a poor application of a behind mount nut. took 5 hours to fit and play with everything to finally get everything to mount and screw together. Would I do it again , yes , A diy with minimal creative knowledge may not be able to see how to make this install work.

Fits the style of the Honda

I purchased the Romik RAL T Silver running boards for my new 2024 Toyota Tundra and really like the way they look and fit on my truck. The install was pretty easy once I figured out where the certain mounting brackets went. They look like they are really good quality and made well too last a long time

I have a Subaru Acent and I am under 5 foot. lifting my leg to get into my car was getting to be a pain. Getting the running boards was truly a blessing. Thank you for your great product.

We ordered running boards for our Ford Bronco. They came quickly and are great. The dealer installed them, and told us the installation was easy. They look perfect and are nonslip. We are very satisfied.

Had installed for $100. Look greta

Good quality and resistant

I was not aware of the consequences of 5.5" boards. There are nice runningboards but too narrow. the price and installation cost is too expensive to replace.

They look good after installed, but the brackets they sent are terrible. I've been an ASE master mechanic for over thirty years and these brackets need a lot of help. All the holes in the brackets are approx. 3/8ths inch. But some of the bolts you use are approx. 1/4 inch. The heads almost pull through the hole. And no flat washers included. I had the add three 1/2 inch spacers in places on both sides to get the boards to set straight and level. Brackets for other units may work better. The ones they give you for a 2020 Jeep Renegade need a lot of work.

just ok. brackets fit great on my jeep grand Cherokee. The board quality was good but my complaint is the boards could not be mounted up tight to the body without the front and back of the board hitting the front fender or rear quarter. may take a saw to the boards to conform the the body front and back. Right now I have a 1 1/2 gap between the board and body mid way. Boards are not custom made to fit this car.