3M 21182 Contact Adhesive,1 gal,Neutral

I used this product on a laminate counter top and had excellent results. I used particle board as the substrate and applied two coats, per the recommendation by the manufacturer, waiting about two hours between coats. After the second coat on the particle board, and the first on the laminate I waited about 1 1/2 hours and joined the two together with a 3" j-roller. The adhesion was immediate and strong. There is some odor with this, but nothing like a solvent based product. Overall I'm completely satisfied with 3M Contact Adhesive and will use again and recommend to others. Just follow the instructions and I don't think you'll have a problem.

This stuff is the best. I'm always surprised when people say that this doesn't work for them. I've used it for years with never any failures. It never takes more than 10 minutes to dry, and that can be helped along with a heat gun. I'm happy to be able to laminate in my shop in the middle of winter without concerns about high levels of VOCs. [This review was collected as part of a promotion.]

Used this to laminate formica sheet to a plywood backer to be used as a RV kitchen countertop. Easy to apply with a foam roller and can be cleaned up with water. Has no nasty fumes or off-gassing. Dried adhesive is not tacky or sticky so spacers slide out with no issues. Once pressed and rolled together the bond is super strong.

It works.

One of the worst adhesive products I have ever used or heard about. What does this stuff even stick to don't waste a second on this stuff stick with contact cement.