Armor All Ultra Shield Ceramic Car Wash - 50 FL OZ

no streaks and repeals dust

great product

Good stuff!.. just follow directions.

Great Soap. Follow instructions on label and you will get amazing results. Have used on two of my cars and both had great results. I did shoot through soap cannon. Reduced soap 1 part to 4 parts water in soap cannon. Good foam coverage. Shine was essentially the same as a spray SiO2 finish spray with just the wash. Would definitely recommend this product.

Can't wait to try this out! Great reviews and I need a foamy wash and haven't achieved that with car soap I've bought in the past. Saw some Videos in this stuff and I'm sure this will foam up my car really good.... bought the $20 foam cannon and can't wait to try that out too! Must buy

Was sort of sceptical about a was/wax all in one. But this stuff works great. I washed the wife's car with regular car wash, then I went over it with the armor all. Wow this stuff does work. It rained later in the day, the water just beaded off the car.. Awesome.

This is an amazing product but it has some serious caveats the most important of which is this: UNDER NO CIRCUMSTANCES SHOULD THE PRODUCT BE ALLOWED TO DRY ON THE VEHICLE. Go back and read that again. This means the vehicle should be washed in the shade and thoroughly towel dried. If you allow droplets or drainage to dry they are definitely going to leave spots or streaks that must be polished out. This makes it critically important that you wash with a purpose and not get distracted. This product works best when used with a foam cannon. Even after heavy agitation in a bucket the foam will last for approximately 5 minutes. In my mind this raises questions about its lubricity and whether long term hand-washing may result in micro scratches. However, when foamed that concern is reduced. I have a 2009 black Corolla that had not been washed in a year. It had no protection and absolutely no beading. I mixed 8 ounces of the product with water in a 32 ounce foam cannon, first rinsed the vehicle with a pressure washer then covered it with the foam. Next I hand washed it with a microfiber mitt frequently dipping it into a bucket containing 2-3 ounces of product and approximately 3 gallons of water and a grit guard. Then I rinsed it with the pressure washer. Finally, I used a regular hose without the nozzle for a final rinse. The beading was absolutely extraordinary. I hand-dried it with a clean microfiber towel and noticed the exceptional shine. My car sits outside and I can say the product continued to bead for at least 3 weeks. Excellent product when properly used. I would have some reservations about using this product on a larger vehicle due to my concerns about it drying before I could towel it off. Even if I foamed and worked on 4 foot sections the product will inevitably splatter onto other sections. And the washed sections might air dry before I completed the job. This scenario would present difficult challenges. Therefore, I do not intend to use it on my standard-sized pick-up. Bummer. My recommendation is for use on smaller vehicles only.

I thought this done a great job for beading water , although I'm in Fl. with daily rain which has made me towel off water after each rain otherwise waterspots everywhere , It may be better if I had a good wax job first , it been about a year since wax.

Leaves stains if you don't remove it faster than you put it on. Stay away.

Terrible product! Go buy any car wash that has carnuba wax. It will give you a better shine and water beading and you will not have to worry about it drying before you can dry it. Im 50 and keep my vehicles spotless. Have never seen a worse product. Apparently some people think its awesome but I wonder how many other products they have used before.