Attwood Turbo 3000 Series In-Line Blower - 12V - White

This is used in a design I made to vent out vapor created while laser etching a product we make. It does an outstanding job of it and is quiet too. For the money, it is a great value as well. It fits nicely in a piece of 4 inch ABS pipe to route the vapors (non toxic but smelly)away from the operators.

i used these to boost the heater air flow in my classic vw and they work great.

Used to blow cool air on the carburetors in my vintage car to eliminate vapor lock caused by 10% alcohol fuel and normal engine heat in hot weather. Cut the legs off and installed it inside of a 4" air duct. Works well for this application. Lots of other vintage car owners are following suit.

I am using this to cool a CVT on a dune buggy. It moves plenty of air. Take note the opening is not 3 inches as advertised, it is slightly less and does not fit 3 inch plumbing. I had to push the plumbing fitting all the way up to the plastic mounting brackets, at that point it is 3 inches in diameter. I'd say the actual opening is close to 2.5".

I replaced my old Atwood Turbo 3000 with this new one. The old one started to make a grinding noise and was driving us crazy. This one works just fine. You can barely hear it with the motor lid closed on my I/O. It is a lot quieter than the old one for now. We will see how long it is quiet for! The price was right. These fans are $30 at most places. Good quality.

Thought it has water resistant connections, guess that is a different model.

great product for the money, I did not find this any were else, for the aplication I needed it for; I will be shopping on walmart.com more often;

first one went to wrong store, but happy with product

Bought to replace rusted out blower. This was the least expensive to purchase. Installed and it worked nicely venting my engine room.

I bought two fans an one of the blowers shorted out immediately