BAKFlip 448101 MX4 (GEN 3) Hard Fold Tonneau Fits 88-14 C/K PU, Silverado/Sierra 1500-3500 6'6" Bed

I went from a ARE fiberglass lid to this. . . Which limits you extremely. . The MX4 cover looks really good. . . . Easy install. . locks with tailgate. . Was missing one screw for the buckle latch, no biggie. . . never throw out extra hardware from any install!! Overall happy with product

My only "problem" which it wasn't for my nephew was the pre-drilling of the hole in the plastic lip of the top body cover. A guide that would not require the clip be in place would have made this installation a bit easier for an old guy with kneeling issues like me. My nephew handled it with ease.

When I purchased my truck it had a Peragon Classic retractable cover. I grew tired of my equipment getting wet. While no coveris100% waterproof I was impressed after going through the car wash. Install . . only one glitch. . it wasn't clear that the front rail tab went in at slight angle and the snapped in. . No real issue with the install even as I did it alone. . great looks and great product. .

My husband is pleased with the truck bed cover. My only complaints is that communication was lacking. We were up against a time crunch and after a week we had not received a shipping notice and i reached out for an update and received a reply that our order was processing. We never received a shipping notice and the cover showed up last week.

This is my 3rd BakFlip install over the past 9 years! I like how easy they are to install. I also like the low, clean appearance of the cover yet how secure they are from casual thieves etc. This new iteration feels lighter and better hinged. I like it!! My only complaint if you can call it that is that the 3 block bumpers have always resisted my attempts to peal the paper from the double sided tape that reveals the sticky side so you can install the bumps to the last panel that rest on the truck rear window. I can never get those to work properly.

I really like the bed cover it is a great product. Installation is through a link and doesn't even bring you to the install. It is the main website. For the cost of the cover they can do much better on that side of selling the product. Otherwise an awesome bed cover.

4 inch long rubber bumpers that the cover edge sits on while fully open, not affixed very well. They were low quality adhesive. Cleaned off and used 3M trim double sided tape to fix. Stuck well now. Was disappointed to to see latches were plastic. Overall, product will work.

I just installed my cover and it looks great. It was a very easy installation. The only part about the cover I dislike is once I put the cover on and looked around the whole thing the spots where it folds were a little torn up. Being brand new that shouldn't be like that.

I tried to communicate this with Realtruck, but there was too much red tape to make it worthwhile. There is a MAJOR issue with the written instructions that come with the cover that I purchased. No where in the instructions does it say that the clamps that hold the rail onto the bed should snap into the rail. If you don't snap them into the rail then the whole thing does not work at all. It will not latch and close up. I had to search Youtube in order to find this.

Canceled my order because it wasn't available. Although after a couple weeks the cancelation is still pending. I no longer trust this company. I simply wanted to cancel and order something else or different make but was not going to until I knew my previous one was canceled. Been too long and I have moved on.