BAKFlip 448307 MX4 (GEN 3) Hard Folding Tonneau Fits 04-14 F150/06-08 Lincoln Mark LT 6'7" Bed

My husband is pleased with the truck bed cover. My only complaints is that communication was lacking. We were up against a time crunch and after a week we had not received a shipping notice and i reached out for an update and received a reply that our order was processing. We never received a shipping notice and the cover showed up last week.

When I purchased my truck it had a Peragon Classic retractable cover. I grew tired of my equipment getting wet. While no coveris100% waterproof I was impressed after going through the car wash. Install . . only one glitch. . it wasn't clear that the front rail tab went in at slight angle and the snapped in. . No real issue with the install even as I did it alone. . great looks and great product. .

The cover is of high quality and fit the truck nicely. I had a Revolver roll-up cover on my previous truck and really liked it as well, but thought I would try a fold up on this truck. Fit and finish is nice. The only issue I have is my truck (and my previous truck as well) has Ram Boxes. While the cover fits good, there are gaps on both sides at the tailgate that lets in quite a bit of water. This was not the case with the Revolver cover (It let a small amount). I do wonder if there is a solution to this. Other than that the cover is awesome.

I needed a new cover for my new Denali pickup. I shopped many other brands and watched many videos on other covers. I decided to buy the the BAKFlip MX4 cover. I watch videos on how to install it and it installed pretty easy. Took me about an hour and a half because I am so particular. I love the way the cover looks. I also like how it folds. It locks down each section. You can also fold it up against the window to give you all the bedspace. I am very happy with my purchase.

Cover is good overall. The instructions could be clearer on the clamping the rails down section. Overall it looks good. However I had a bumper peice fall off already. The one that sits flush on top of the cover by the cab window when not in use. Hopefully it lasts a long time.

Installation was much more difficult for the Maverick than what is indicated in the Realtruck video. For $1200 it would have been helpful for an instruction sheet specifically for this model to be included. The tolerances for the Bakflip are so precise that any small imperfections in the truck bed are problematic. The drivers side latched perfectly but the passenger side would not latch for all three latches. Yes, the railing was installed correctly and identically on both sides. Determined that the truck bed was slightly leaning in on the passenger side. Had to correct by placing a flat washer as a shim under each latching mechanism. Also, the thick pads included to protect the cab are not thick enough for the Maverick. When the bed cover is flipped up it rests on the cab and the pads do not reach the cab. The rear window is recessed from the cab frame and the pads do not reach the window. The only place where the pads would actually work are on the very edge of the cover, and then it would not be able to close.

It was very Disappointing or may be my expectations were to high!!!. . . never got the cover to latch naturally and properly unless you help it or force it ( is not the way it supposed to work ) the clips that holds the bed cover tight with the railing interfere with the hardware ( ended up both line up in the same spot ) plastic clips on the end of over railing sistem comes loose pretty easy ( not supposed to be like that ) installation were rate as easy to install ( turned into a headache ) got me working on it over 3 times. In Resume. Overall quality i think was poor ( I could expect that from an unbranded product from Amazon or so ) not from the a top saller product

I tried to communicate this with Realtruck, but there was too much red tape to make it worthwhile. There is a MAJOR issue with the written instructions that come with the cover that I purchased. No where in the instructions does it say that the clamps that hold the rail onto the bed should snap into the rail. If you don't snap them into the rail then the whole thing does not work at all. It will not latch and close up. I had to search Youtube in order to find this.

I originally had a cover bought off amazon and it fits perfectly. I wanted to have a stronger cover and tried this one. However, water seeps in when it rains and in carwashes. My original cover bought cheaper from amazon doesn't do that. I hope they created it a little 0. 5 longer. Waste of $$$$.

I ordered my part almost a month ago. I have not received it. I tried numerous times to get an update with no success. I am heading out for an extended trip and I needed the topper. Now I have to consider not having the part I needed for my trip. To add insult to injury I am being asked how I like the part I never receive. Kind of silly. Not a great first experience of a company that is “apparently” highly regarded. I am not a person of high expectations I just would like to know if I will get my part in time to install it before my trip. They took my payment. Will they be just as eager to return it? We shall see in 2 days when I will demand a refund.