BAKFlip 448427 MX4 (GEN 3) Hard Folding Tonneau Fits 16-23 Toyota Tacoma 6'2" Bed

I needed a new cover for my new Denali pickup. I shopped many other brands and watched many videos on other covers. I decided to buy the the BAKFlip MX4 cover. I watch videos on how to install it and it installed pretty easy. Took me about an hour and a half because I am so particular. I love the way the cover looks. I also like how it folds. It locks down each section. You can also fold it up against the window to give you all the bedspace. I am very happy with my purchase.

I really tried my best with help to make the side rail square with bed sides. The foam strip seems to put the rail at an angle. I loosened/tighted the rails to no avail. The cover does leak but not excessively but it leaks. Any advice would be appreciated. S.

My husband is pleased with the truck bed cover. My only complaints is that communication was lacking. We were up against a time crunch and after a week we had not received a shipping notice and i reached out for an update and received a reply that our order was processing. We never received a shipping notice and the cover showed up last week.

My only "problem" which it wasn't for my nephew was the pre-drilling of the hole in the plastic lip of the top body cover. A guide that would not require the clip be in place would have made this installation a bit easier for an old guy with kneeling issues like me. My nephew handled it with ease.

Materials seem to be good quality. Bed cover is sturdy but does not adequately cover the bed. There are a few gaps that do not seal well. Will work well for keeping items safe from theft, but I would not recommend if you are looking for something that is watertight. It comes with drain tubes which can route a lot of water out of the bed, but a lot of water still ends up in the bed of the truck.

Installation was much more difficult for the Maverick than what is indicated in the Realtruck video. For $1200 it would have been helpful for an instruction sheet specifically for this model to be included. The tolerances for the Bakflip are so precise that any small imperfections in the truck bed are problematic. The drivers side latched perfectly but the passenger side would not latch for all three latches. Yes, the railing was installed correctly and identically on both sides. Determined that the truck bed was slightly leaning in on the passenger side. Had to correct by placing a flat washer as a shim under each latching mechanism. Also, the thick pads included to protect the cab are not thick enough for the Maverick. When the bed cover is flipped up it rests on the cab and the pads do not reach the cab. The rear window is recessed from the cab frame and the pads do not reach the window. The only place where the pads would actually work are on the very edge of the cover, and then it would not be able to close.

It was very Disappointing or may be my expectations were to high!!!. . . never got the cover to latch naturally and properly unless you help it or force it ( is not the way it supposed to work ) the clips that holds the bed cover tight with the railing interfere with the hardware ( ended up both line up in the same spot ) plastic clips on the end of over railing sistem comes loose pretty easy ( not supposed to be like that ) installation were rate as easy to install ( turned into a headache ) got me working on it over 3 times. In Resume. Overall quality i think was poor ( I could expect that from an unbranded product from Amazon or so ) not from the a top saller product

This cover does not align properly for all latches to click into place with out manually pressing up on the rails and down on the cover at the same time. It requires modification to the bed of a 2025 tundra for the drain hose to fit. It also leaks significantly from the corners closest to the cab which causes water to puddle where the drain hose goes through the bed. The water will not drain from the bed because the hose occupies the drain holes. I had a gator cover and never had these issues. I have reached out to Real Truck and BAK for support but was told by BAK that I had to go through Real Truck but website says same company. Real Truck is unresponsive.

I set a tire on top and drove around the building, which is about 200 yards and that's a big circular scratch on it. I didn't realize I was buying something with such a soft surface where I wouldn't have. Truck denied my request to return it even though they have the monopoly the industry. I'm not impressed.

Canceled my order because it wasn't available. Although after a couple weeks the cancelation is still pending. I no longer trust this company. I simply wanted to cancel and order something else or different make but was not going to until I knew my previous one was canceled. Been too long and I have moved on.