BAKFlip 448440 MX4 (GEN 3) Hard Folding Tonneau Cover Fits 22-26 Tundra 5'7" Bed

The cover is of high quality and fit the truck nicely. I had a Revolver roll-up cover on my previous truck and really liked it as well, but thought I would try a fold up on this truck. Fit and finish is nice. The only issue I have is my truck (and my previous truck as well) has Ram Boxes. While the cover fits good, there are gaps on both sides at the tailgate that lets in quite a bit of water. This was not the case with the Revolver cover (It let a small amount). I do wonder if there is a solution to this. Other than that the cover is awesome.

Fairly easy install. The videos help a lot. I had a slight issue with the rails leaning down slightly after being tightened. This kept the latches from catching when unrolled. After re-installing several times to see if I'd done something wrong, I just used a pair channel locks and bent the rails ever so slightly where the latches would make contact. Just enough to get it to latch without actually being able to see it. Worked great from there out.

I was able to install this at home in about an hour, following the YouTube video on the Real Truck website. That was SUPER helpful. Really pretty straightforward. Getting minimal leaks (and I think that's mostly from the gap in the existing tailgate) and I've used it now in 2/3 open and full-open positions to haul things. Looks great on my 2025 Ranger.

4 inch long rubber bumpers that the cover edge sits on while fully open, not affixed very well. They were low quality adhesive. Cleaned off and used 3M trim double sided tape to fix. Stuck well now. Was disappointed to to see latches were plastic. Overall, product will work.

Installation was much more difficult for the Maverick than what is indicated in the Realtruck video. For $1200 it would have been helpful for an instruction sheet specifically for this model to be included. The tolerances for the Bakflip are so precise that any small imperfections in the truck bed are problematic. The drivers side latched perfectly but the passenger side would not latch for all three latches. Yes, the railing was installed correctly and identically on both sides. Determined that the truck bed was slightly leaning in on the passenger side. Had to correct by placing a flat washer as a shim under each latching mechanism. Also, the thick pads included to protect the cab are not thick enough for the Maverick. When the bed cover is flipped up it rests on the cab and the pads do not reach the cab. The rear window is recessed from the cab frame and the pads do not reach the window. The only place where the pads would actually work are on the very edge of the cover, and then it would not be able to close.

This cover does not align properly for all latches to click into place with out manually pressing up on the rails and down on the cover at the same time. It requires modification to the bed of a 2025 tundra for the drain hose to fit. It also leaks significantly from the corners closest to the cab which causes water to puddle where the drain hose goes through the bed. The water will not drain from the bed because the hose occupies the drain holes. I had a gator cover and never had these issues. I have reached out to Real Truck and BAK for support but was told by BAK that I had to go through Real Truck but website says same company. Real Truck is unresponsive.

This company knowingly shipped me the bakflip mx4 with rails that didn't fit my truck (2024 Tacoma 5') with zero communication. When I contacted them they say the rails are under review and no ship date is planned. Total scam! Do not buy from these folks and stay away from bakflip if you plan to actually have this system on your truck

I had a 2017 Ridgeline and loved the Bakflip. Purchased 2025 Ridgeline and a new Bakflip and could not get it mounted - rails are not as sturdy and I found others online with similar issues. Went back and mounted the 2017 Bakflip onto the 2025 Ridgeline and it was simple and easy. RealTruck really needs to look at the design of the rail systems.

I took it to a professional install place for BakFlip. They say the parts for 2025 pro 4X was not great . They had to adjust finally got it to shut. But they told me today to reach out to you and say it not a normal installation. ( I try to reach customer service but it was a 30 plus min wait. Today 6/4/25

Well let's see. It's been over a month since I placed my order. When I placed my order, the product was supposedly in stock and ready to ship. Still nothing. I am going to cancel my order and get the same bed cover from someone else. But since you asked for a review, here it is.