Bell® Baja Blanket Standard Bench Seat Cover 3 pc Box

Product was exactly as shown. made of good durable woven material(cotton) A few things to say, The 2 front seat covers I was able to get off the shelf and installed easly and fit good considering one size fits all. Back seat was a bit more difficult (my Fault) My seat folds down in two sections, Cover comes in one peice.For me the seat belt holes didn't match up, and there was no way to install it with out cutting additional holes for the seat belts unless I pulled the seat out and unbolted it from the car (lot of work) I choose to cut and custom fit. this took about three hours.and alot of hand sewing, plus additional material to tuck between the seat sides and top. all in all it looks pretty good, (just hope it last a long time, I dont want to do that again. Walmart did price match K-Marts close out price so that made me feel much better about having to cut it up Price match saved me over $15.00. All in all walmart did good, and everything worked out.

I own a nisson frontier the cover is a bit loose but was easy to put on its one piece with separate covers for the head rest the head rests are a bit small

After debating on getting my seat redone I went to walmart online and found this seat cover for half the price! It looks like a custom seat cover in my El Camino!

I bought this for my Mazda 3 and it doesn't fit perfectly, but it's not bad. A little tucking and it looked just fine. The material feels a lot stronger than others I have seen at higher prices. Plus, the pattern really hides dog hair and anything else that may spill on it. I bought this to cover the back seat that my dog chewed. It looks good and serves the purpose.

I already have my 2011 Subaru Forester's front seats covered in this pattern. I receive lot's of compliments on them. They fit well. They have been on for about a year. I ordered the bench seat but found out it will not fit snug like the front due to not being able to slip the tension tab through to the trunk. So this review is mostly saying it will not fit my year Subaru Forester. But this pattern and fit on the front seats are fine!!!

Very pretty once you get it one. There is a strap that goes behind the seat that would fit "most" truck benches. This is not a perfect fit for a Tundra Double Cab since the back seat does not lean forward. We had to cut the strap. We also have 3 head rests so we just removed one for now.

2nd one I have owned. The material is sturdy & fits a full sized truck bench seat. Side material a little flimsy. Stays in place nicely, once you secure properly. I also bought the bucket seat version of this in Walmart store & its one piece, so adjusting head rest a pain if you need to.

I got two front seat covers and they worked fine in my 2000 VW Beetle. I then opened this bench seat cover and realized it was for an SUV. We tried to make it work and it's still in my car. Does it look as great as I would've hoped? Nope, it sure doesn't. Hopefully with some safety pins and tucking we can make it look better. I will say however that the head rest covers fit great. Overall I love the seat covers, just wish it would've fit better than it did!

I bought this item to protect my back car seat from my dogs. I have a 5 year old Subaru and it fit, but not snugly as I would have liked it too. There are straps that go through the folding part of the seat, but my car seat is covered in the back and I can't pull through. So, bottom line, I think it was made well, but it depends on how your back seat is made to have it fit properly.

The loops were not attached securely. When we pulled the straps to tighten the cover around the seat, one loop pulled off the cover. There was no use going any further. If that loop didn't hold, why would we spend time on the rest of it just to fine another one. It's a nice looking cover, but it could use some pockets and sew the loops on better!