Biltek 50Amp Air Plasma Cutter, 1/2" Inch Cut 110V/220V Input DC Inverter Dual Voltage with Pre-Installed 110V US Plug, Portable & Easy Quick Setup Metal Cutter

Handy plasma cutter that was able to cut through 1/2in of steel easily.

worked great,110v plug it in anywhere

You dont get 220 plug its just 110 plug they miss represented plasma cutter

Liked it so much I bought another one. Great little cutter. Cut though a mole board the is hardened steel and over half an inch thick. I like to 120v side for cutting better then switching to the 240v side. Cuts so good I got a second one for a spear. And I have a $600.00 cutter that the Beltec for $189.00 cuts far better then the big one cuts. So I'll sell the big one and keep the little ones. Thank you Walmart.com for your quick delivery and service and I'll be a customer to the end. Amen.

I have never switched it to 220 yet however it works very well on 110 . on a 110 volts at 50 amps it's straining its limit at anything past quarter inch . with quarter-inch steel you have to go slow but it'll still make a clean cut .

Cutter work's grate and cuts clean

doesnot work that well on thin body metat it said it would cut up to 1/2 in thick I dont belive it would do that at all

you have to have torch head like right on the metal and it will not cut 3/8 or 1/2 inch on 110 . there is no 220 plugin. i just cut 3/16 or 1/8 inch . it doez the thinner material just fine , but i bet you replace alot of tips.

I'd doesn't work and I'm not happy with that fact .

I just needed something to do very small jobs occassionally. Thought this would be perfect. However it quit within minutes the 1st time I plugged it up. Returned. I will not replace with this kind. I will buy something different