Budge 1200 Denier Center Console Flat Front Boat Cover, Waterproof Outdoor Protection, Size BTCCD-8: 24'-26' Long, 106" Beam

This is a great boat cover. It doesn't fit exactly perfect but that's ok because it's very high quality, has a built in heavy duty elastic band, vent holes so the boat interior can breathe which are also partially covered so as to not let rain water in,and last but not least it has 4-5 underbody straps to hold the cover down. The cover also has a 5 year warranty and even comes with a small patch even if the cover does tear at some point. My old cover had a 3 year warranty, tore after 2 years, had less features, was always moldy, and cost twice as much as this one. To me, this was a great purchase and I'm very happy I went with this company. Thanks Budge Covers !

The cover is made of really quality material and the elastic is very strong so it should stay put. The fit on my boat is a little large but nothing a few extra tarp clips won't fix. I do wish they sold the poles so it would be a one stop shop but I think it's going to do the job really well.

It is completely water proof. We had a weeks worth of heavy rain after getting the cover. It has kept the inside of the boat completely dry. The cover fits my Formula 242LS perfectly as well and the straps holding it down to the trailer make it easy to get in and out of the boat without uncovering the whole boat

Just received this cover for my 2009 Sea Hunt Ultra 186 Center Console. I am very impressed with this highly durable, well made cover. Hopefully it will last many years. It is long enough to also cover the top half of the 150 hp engine. I also purchased the XXL engine cover to protect the entire top section of the engine.

I have bought several covers over the years to cover an old fiberglass jon boat. This cover by far is the most heavy duty at 1200. I also purchased two of the poles to hold the cover up so rain and snow will not collect. I recommend this to anyone looking for a quality cover.

Nice cover thick and very tight fit. Only thing is it should have had some sort of inset so it would fit around the motor. The cover gets puddles in the gaps by back section because of the tight fit by motor. Other than that it seems heavy and strong and hopefully will last, it’s only been on a couple of days

This seems to be a high quality cover that wasn't overly expensive. The material appears to be well made and should prove to be durable. It fits quite snug and is a little difficult to install but that probably helps keep in place during high winds. The only thing I would like to see improved would be to add some type of extra material where it rests on the usual sharp edges such as windshield corners, etc.

Feels like a good quality cover . However, it doesn't fit well over the back as the motor and controls are not covered leaving a large space that can't be completely enclosed. I would say it was my oversight except for the fact that all Lowe Stryker 17' boats come with outboards. This design for this type of boat could be better..

The cover fit good on my 19ft boat, however on the fist trip down the highway a strap connector came off... the sewing on this particular strap was not very good... I didn't return I just hand sewed it back on hopefully none of the other straps come off...

Build quality is good, really like vents. Cover seems very oversized for the boat, don't see how it would trailer well without a lot of wear and tear. Cover is big enough to also cover the motor which means I don't need the motor cover. Emailed factory and was the correct cover so it is not a misfit.