Comgrow PLA 3D Printer Filament, 3D Printer PLA Filament 1.75mm, Dimensional Accuracy +/- 0.02 mm, 1KG Spool PLA Orange

I have looked at a few different black filament, and this one seems to match old plastic parts around the repairs that I'm making very closely. some lots have more blue to the black and it doesn't match the older work as well. I fabricated a sliding mount and some stops for a tripod rig, and it's holding up very well.

I'm too "new" to "3D Printing to have an intelligent complaint on the material or how it renders final "3D" models. But , so far , I have not encountered any issues with regards to my first full print project.

The role is fine, but it's damaged like somebody dropped it maybe the shipping company they used dropped it because I'm getting kinks in my line when I'm printing I'm having to keep an eye on it But overall it's a good value.

Overall, I was pleased with the product because it arrived on time %26 was great quality... HOWEVER... I ordered the combo pack of black, grey, white, red, blue, and yellow. Instead of yellow they sent me orange, and not like a almost yellow orange either. like a bright pumpkin orange thats clearly labeled as being orange. Besides that 5 of 6 rolls was like they were suppose to be.

Looks great and prints great with a smooth finish, but it is really brittle. Messed up half the prints I used it on because it broke pat meant through the print. Broke inside the extruder 3 times. Got 6 colors of the same filament in the same shipment and all except white were perfect.

The colors were good and they all worked well except white. The white is very brittle and I have had to take the printer apart 3 times to remove broken filament. Only the white though. All the other colors have been great. Maybe the white was just wet or old?

The filament itself seems fine, the finish is ok, other than having slightly weaker adhesion to the layers able and below a layer. The problem I ran into was at the end of every width of the roll, the filament was trapped under the next lay on the spool. So it gets stuck and on more than one print so far it has caused a print to fail, hence the lower value for money rating. I have to be nearby to keep an eye on it literally the entire print or loosen an enormous amount of it. I have a print running right now, and it was so tight it actually broke the filament.

I'm not a fan of this brand. The filament broke several times in the tubing and was tangled on the reel. I had to spend a lot of extra time troubleshooting my printer to find out it was the filament causing all of the issues. I really liked the colors offered and the variety but in the future, I'm going to purchase a different brand of filament. I actually had to take part of my printer apart to retrieve a segment of filament that broke off inside the extruder.

Stay far away from this filament! It is incredibly low quality and severely damaged my Bambu Lab A1 Mini. My printer is brand new with only 21 hours of use, and this defective plastic completely clogged the machine and broke the nozzle. I've attached photos of the damage as proof. I have already contacted them demanding a refund and full compensation to fix my machine. Do not risk your printer on this cheap material. I will never buy from them again.

While I ordered the product for the convenience of being a bundle pack I was sure to read what was included ie the colors specifically I ordered other colors separately to not have doubles or extra I purchased these knowing they came with black white gray red blue and yellow I ordered green and orange aswell as pink and various others but now I have no yellow and 20 percent of my designs need yellow now I'm at a stand still every thing else as in packaging and being sealed all checks out perfect just this big problem no yellow even though it states it will have yellow