Compatible with Hoover WindTunnel V belt - 1 Pack - Part # 38528-034 By Vacuum Fix

I did not receive this Item.

Very good quality for the money.

Does not fit a Hoover wind tunnel. It broke the 1st time I used it

Installed easily and works as it should.

The Wind Tunnel vacuum has two belts. The larger V belt is used for motorized movement of the vacuum - a system I almost never turn-on to use and uses the larger belt. The smaller belt is used for movement of the brush head. When the brush head stopped rotating (on a smooth wood floor) I new it was time to replace the smaller V belt- it may over time stretched to become a loose fit. I replaced both V belts (just to make sure) and there is still too much slack (looseness) in the brush head belt. (Yes, I checked the part number to make sure I ordered the correct part as listed in the instruction booklet and On-line and shown on the belts). Then, I checked the smaller belt length with the "old" belt and they both were the same length? Yes, there is only one way to install the belts. What's next, let the vacuum sit taking up space or order another belt using the same part number as the previous order? Would I purchase this vacuum (Wind Tunnel) again? Not until the replacement parts issue is resolved. Hoover is a big brand (been around a long time), they need to fix this parts issue to attract new customers. HOOVER STEP-UP!