Creality Ender 3 V2 Upgraded 3D Printer Printing Size 220x220x250mm Aluminum Black

Great! My 15 year old received it. He spent some time assembling it. Was a good experience. He put some time into adjusting it to get good prints. Works very good now. He has and is still learning a lot from it. Very nice 3D starter printer. It has been about 72 days now.

A low price is not a good thing in this case. These are bare bones printers. I could have spent less time and a better learning curve and spent the same money just buying an Ender with all the best parts allready assembled. though it was fun to buy the parts and enjoyable all around. I wish I had taken a friends advice and just bought a higher end point printer, way less stress and mutch better parts. The price point and the quality of this printer are good, great even, can do anything you want to print.

Was recommended to me by several friends, turns out they were right, good quality machine, a bit complicated to build and set up, working for me perfectly.

I absolutely love the printer, however the extruded tube keeps getting clogged and it annoyed me since the second week of owning it. I could just replace the tube but then I wouldn't have anything to complain about. Haha, so to summarize my experience, I love it and I'm going to buy another just like it. I hope you enjoy yours as much as I enjoy mine!!

works great an amazing 3d printer

Printer is good but a lot of work to put it together

you haven't more than anything. i love you guys

Good luck setting it up!!! Instructions are impossible. Customers service is non existent from Walmart!!!!

I encountered significant issues with this 3D printer, particularly with the bed leveling. Despite numerous adjustments, the bed refused to maintain a level position, requiring constant recalibration. The Z-axis switch was another source of frustration, failing to stay in place even after being raised. As a comparison, I own an Ender 5 Pro, which I can level flawlessly without any of these problems. This printer, however, presented additional challenges. The bed would collide with the rear motor, altering its position and leading to subpar print quality. Even after raising the Z-axis switch, leveling remained an issue. It was either too high or, after minor adjustments, would revert to hitting the back again. For those considering this as their first printer, I would advise against it. Instead, opt for a printer with an auto-level feature to avoid the constant need for manual adjustments. This will save you time and ensure more consistent print quality.

I have given it a lot of tries with this printer. Taken every single troubleshooting step and my prints are always stopped or messed up. Not worth it.