Estrella 3-drawer File Cabinet Antique Nutmeg and Gunmetal

the wood matches my desk and fits my cannon printer on top just fine. the 3 drawers work. have only 1 issues the knob on the 1st drawer came slightly bent.

Packaged very well, so arrived in excellent condition. Instructions were clear and put together quite easily. Only noticed that as I screwed each drawer to the slide track, a few screws began to split the draw side wood. Not deep but enough that I added wood around the screws when in place. Cabinet works great and I love the look.

The product was super easy to assemble and comes with a file drawer. The two upper drawers are smaller but still great for paper and toner. It was well packaged so no damage to interior pieces.

Looks and works great. It did take over 3 hours to assemble, but was worth every minute. Love my new file cabinet.

It was easy to put together and looks just like the picture. Exactly what I wanted! Added bonus: It was delivered in two days.

This fine cabinet is perfect for my office. Holds more than I expected.

Nice, heavy cabinet. I am using it as both a printer stand and file cabinet. The only negative thing about it is the plastic drawer pulls which do not match the industrial feel of the piece and are mounted using two screw holes. Easy to add a better pull but have two holes makes it a challenge.

Sturdy cabinet but a couple of places the particle board split when screws were entered. Overall good purchase. Not difficult to assemble. Would buy again.

Looks great but be careful when putting it together. We screwed the top screws in too tight and had damaged the veneer in four places on the top when we turned it over and we also split the wood in another place. It's all veneer finished.

I have the desk and shelves for this same collection, which I had no problems with, but this cabinet was another story. You CANNOT use power tools on this piece; you can barely even use a screwdriver by hand without splitting the sides of the drawers. The drawer pulls are a plastic, shiny silver, which doesn't make much sense to me seeing the rest is gunmetal. I will more than likely switch the pulls out for something nicer. The feet of the cabinet also serve little purpose, they don't lift the piece up, which causes the bottom to get stuck if you have it on carpet.