Harbor Master 300-Denier Polyester Water-Resistant Jon Boat Cover Gray

good quality, stretch fit is tight. It rained and the cover held about 2 gallons of water, which I bailed out and it dried quickly. The cover was water-tight. My only complaint is the lack of any size information on the ad or box. There are 4 sizes, depending on your boat, and I only rolled the dice that it would fit my boat. Even looking up the skew number on the internet didn't answer my question. Good thing Walmart lets you return everything for free. Turned out, I got the corrent one for my 10 ft jon boat.

This is a well made boat cover. You can customize the straps that go underneath the boat so that you don't have excess straps hanging around looking messy. The cover also has a elastic band that runs around the edge, so that the cover grips the boat. If, for some reason, I need another boat cover, this is the one I will buy. I have seen more expensive covers that are not near as well made.

Easy to use a lot of tie downs. So far its went through heavy wind and rain and some snow. I put it on a 16 foot lowe big river jon but i got the 18 foot one so it covers up the outboard motor too. it looks good on the boat and thats important in my neighborhood.

takes a few minutes to put the cover on but it fits my jon boat perfectly. Has a cut-out for the motor and plenty of tiedown straps, put an open folding chair in the center of the boat to tent the cover so the rain runs off. It has already lasted through a couple of rain showers. Works great!

I bought this cover for my 14 ft. jon boat and it fit great even with raised pedestal seats and bow mounted trolling motor. I really like the straps that just snap into the attached buckles.

Used it on a 14-foot V-hull aluminum boat. While there was some excess cover material, because of the strap-down system, this still worked very well. Good cover for the price.

The cover fits really nice. When the wind blows it has a nice fit, no flapping.

This is a very adequate boat cover. I keep it on except when in the water, even when going to and from the lake. It has no problem with 65 mph speeds. If you want to keep water from pooling on it you will need to put some pvc hoops in your boat to allow the water to run off. While camping had a thunderstorm which put down over 1/2 inch of water, which had to be bailed because it pooled up on the cover. The side release buckles won't hold too much weight and will fail in time, just like any others, so have some handy for when they break. This product is plenty sturdy and Walmart has the best price by far. If you need a cover for your jon boat this is a worthy consideration.

fit snug, would have liked more room. came without one of the female connectors so I am having to return it. The manufacturer Harbor Master did not return my email about returning the product so I am going through Walmart. All on all it is a nice cover for the price.

I like the cover. As you can see from the pic, my seat extends above the gunwales and the the cover still fits my boat well. It has an elastic cord at the bottom of the cover, keeping it snug around the circumference of the boat. Also, it's easy to handle if you launch by yourself. Long straps allow you to strap around your trailer, should you wish to do so. There is also a cut-out at the back, to go around your motor, and a strap point, to secure the cover.