Hyper Tough 31cc Gas 4-Cycle Gas Walk Behind Edger

I wanted a gas edger for some time now, this little machine was in the price range that I wanted to stick to. I was delivered a couple of days after I ordered it "liked that" I assembled it in less than 10 minutes. I took a few minutes to get it started, but it runs and works like a champ.

Starts easily and every time so far. (4 months in) I guess it will continue to do so if the fuel is properly treated and run dry every winter. been a wonderful edger. I looked and looked for a few months before deciding on this one after being let down by several other electric models and cordless models. this little guy gets it done!

Nice edger, works well, easy to use. Only reason for not getting 5 stars, the blade came installed backwards, cutting edge opposite of direction of rotation, so blunt edge was leading edge of rotation. Shapened edge should be leading edge of rotation.

Reviewers wernt kidding when they said it was hard to start. it took forever to get it fired up. so i tried a different way.... don't choke it and don't prime it.... the lever up on the handles that controls the engine speed when it's running....squeeze it....2 times. then try to start it. Mine has started on the first pull every single time since I've started doing this. 4 stars instead of 5 because i can't find replacement blades yet. otherwise I'm quite happy with it👍

hard to Start due to need to hold starting trigger and pull rope at the same Time and also holding mechine against the floor so it won't mover while you are pulling.

I loved this unit! It was very easy to put together, mostly just the handle. The body comes in one piece. You have to buy a quart of oil ( uses about 3 oz). I don't know why the manufacturer doesn't include a mini bottle along with the edger. It started very easily and ran great. I used it for about 2 hours, it edged beautifully with one major drawback. After using it I checked the oil and the plastic dipstick had started to melt inside the housing. In fact the tip was missing! That is the reason for the low rating, because it was just a matter of time before that small piece of broken off plastic would shut down the engine and ruin the edger. Why do you make a great little unit like this and then use a cheap plastic dipstick! I would buy again if they replace that with metal.

The frame is extremely flimsy. I had to stick a piece of cardboard under the motor to support it and keep the whole thing from vibrating because the motor is mounted to the flimsy frame on the side with the blade. The spot welds don't look very confidence inspiring for longevity. The lever for the choke and run position is very fragile and thin plastic so that will probably break quickly as well. The front wheel is bent, don't want to forget to mention that. The design is good, the quality and choice of materials is very poor.

Does not seem to that bad of a product but the catch is that it uses 9 1/4” blades with a 1” center hole. You can't find blades any where for it. You can forget manufacture it is made in. China they have no office in USA.. Would not buy this product..

Junk. Starts like a 10 year old engine that's been left out in the rain. Cuts rough - my cheap, $30 electric edger ru a circles around this. Obviously had something in the engine (from the factory) since it kicks out smoke almost the entire time it runs. If it's offered to you for free - say no. Walmart refused to correct it and the crap company ignores everything. AWFUL.

As far easy to assemble good thedesign good easy to use good I hope I got a defective one when it got hot it quite running and would not start for 3-4 hours i returned it and ordered another one