JEGS Plasma Cutter, CUT-40 [20-40 Amp, 110VAC/220VAC]

IT CUTS THICKER METAL THAN IT SAYS IT CAN. VERY HAPPY!!

Works great, never operated a plasma cutter before easy setup

This has been by far the best purchase I have made in awhile. Cuts with ease. Highly recommend

Good plasma cutter for the money. WIll cut thinner metals with 120 volt power, but really need to run it on 240 volt power supply. Don't forget you will want a filter to remove water from your airline. absolutely no problems with it after 2 weeks of use.

A great addition to any garage mechanic's arsenal of tools. Used it to cut shock towers on a 65 Mustang and some Mustang II suspension metal. Worked good on 110 volts, but even better on 220 volt. Good cutter for the price and way better than running through cut-off wheels on the angle grinder. Took the advice of other reviews and opened up the case to check all the air connections. Some needed attention/tightening, but not a huge deal.

Works awesome. I’ve cut up my truck and built stuff with. Cuts half inch steel in one single pass. don’t let the posts about an air leak keep you from buying it. Mine has a small leak in the regulator but doesn’t effect its performance one bit. Thanks Jegs

Pretty simple to use once figured out. I would recommend better instructions and maybe some helpful tips. I had to watch a video on youtube before I started using it to guide me in the right direction. After that if was easy. Also, the hand held face shield is terrible. The lens was as dark has a welding helmet. I could not see my project. I would recommend an inexpensive pair of tinted safety goggles. The machine is perfect for what I am doing and was priced right for my budget. Thanks for offering a great little machine!

Great unit! Worked well right out of the box. Make sure you have enough air compressor to keep up with it.

This plasma cutter is very good for the price and works well

I purchased this a couple months ago. It shipped without the grounding cable. Jegs customer service was excellent and shipped me one out immediately. First chance I've had to use it, and I've spent 6 hours and made about 14 inches of cutting. Thought it was my ground, so I went and bought a big magnet grounding connector, ( contact area is VERY CLEAN , BARE METAL.) After I change all the consumables, I get a brief arc and that is all. Change consumables again, brief arc, and repeat.