K&N Performance Cold Air Intake System: Easy Installation, Engineered to Maximize Airflow, Boost Horsepower & Torque, 63-3082

Never actually received the item something to do with shipping but buy it off and buy it from Facebook marketplace it's a whole different experience, especially with a tune if you got an after Mercury exhaust syste never actually received the item something to do with shipping but buy it off and buy it from Facebook marketplace it's a whole different experience, especially with a tune if you got after market exhaust system like I do the flow Masters for my 5 market exhaust system like I do the flow Masters for my 5.3 Chevy Silverado 1500. You're nervous that rumble that comes at higher RPMs roughly round 3000.

Great quality. Sound increase when getting on accelerator makes it sound deep. Only thing that the heat shield rubber covering was a pain in the butt. And the fact 2 plastic bolts were given to insert in a metal thread made stripping it about half more common

Just wanted everyone to know I purchased this product last year, it's been pretty good, but during routine maintenance noticed a cracked intake tube. From tube to coupling for trottle body. Most likely cracked over winter, but was surprised. The reason for the review is how GREAT K&N responded. They didn't skip a beat an within 2 days new part arrived. Now that's a company I want to do business with. Thanks again K&N, see ya down the road!

K%26N original part. Made my truck run better. Price at Walmart was better than anywhere else.

Easy to install. Sounds great! Saving aprox 2-3 mpg on my 16' silverado

Greatly helps my 6.2 liter Yukon XL. The only drawback is the noise level is much greater than anticipated. That kept it from getting a 5. I am a long time K&N user, however this is the first time bought more than a filter. Sound level is OK, but moderate acceleration sound is greatly increased. Under hard acceleration, WHO CARES?!

I recently knstalled a K&N 63-3082 intake kit on my 2014 Silverado, 5.3. I am very pleased with the results. Low end lag is greatly reduced. I picked up a couple more MPGs and I love the growl. Also my kit was short 1 vent tube fitting and the good folks at K&N sent me two, no charge. Look no further, K&N is the best! Always has been, always will.

Purchased mine almost a month ago. It was easy to install and it sounds great!

Whenever you install the MASS AIR FLOW sensor at the end of the installation. Crank it up and few times and drive it around for a couple of miles. Then try and crank it again. It will act like an old school flooded carb. When it does this, take the MASS AIR FLOW sensor back out of the intake and clean it very gently with a Q-tip and some alcohol and reinstall.. There's way too much oil on the K&N Filter and pretty quickly it ends up on your sensor and then it won't run worth a flip.. Hope this helps..

It did increase performance a little but not sure about the excessive sound could be annoying when towing a trailer not sure if I will leave it installed or go back to original .