K&N Typhoon Cold Air Intake System: Easy Installation, Engineered to Maximize Airflow, Boost Horsepower & Torque, 69-2544TP

🔥This CAI is Sweet & Smooth, once fitted with some ⚡️RIPP coils, can feel and hear the difference, It will not disappoint, definitely recommend ✨Pretty easy swap no mods for the savvy motorhead ✨

We bought this for a 2020 Challenger GT. The engine sound is insanely loud and much deeper under hard acceleration. It made the challenger actually sound like a muscle car! Also got a noticeable boost of power and torque! I recommend this to anyone that has this car.

Money well spent for this system. To me it really woke up that sleepy 3.6 and even gave some growl to it. K&N did it again, you won't regret buying this system. Great product, pretty easy install, like I said well worth the time and money spent on this setup. Thanks K&N

My previous K&N high flow breathed through a hose. This one has a much greater internal volume capacity as it seems to me to be chrome plated steel. Stronger than the equivalent measure of aluminum and it is nifty to eyeball when one lifts the hood. No problems with any rust and this point. Cool.

Great product. Love the sound of the engine. May be to loud for some inside the vehicle. But worth it. Also be careful with some of the plastic pieces as they may break.

Modifications required to plenum stand off bracket to avoid preload (appx. 3/8" too short).

Came out super nice and the install was super intuitive. My only complain is that the upper and lower rubber covers for the heat shield were missing in my kit. Other than that, it sounds amazing.

Awesome intake, was pretty easy to install however the instructions were not made for the 2020 Challenger.

The install would have been a lot faster if the images weren't blurry or if they were relevant to the vehicle. With 2011-2023 being the applied models, there have been multiple changes to the design. Also the nuts and bolts aren't labeled on the instructions or in the package. It's not rocket science but it would be faster if they were labeled. The 90° plastic broke and I had to figure out a solution on the fly. I used the secondary 90°, reduced the diameter of those threads, wedged it into the broken threads in the pipe and heat welded it with a torch. Solid as a rock. Other than that, the sound is amazing and looks great. Hard to tell if you can actually feel the extra 8hp or if it is placebo effect.

Purchased for a new Dodge Challenger, upon arrival the throttle body side of the tube was mangled and dented. Temp sensor would not fit into the hole without removing the gasket and it fits loose due to poor machining. Plastic barb for the crankcase breather snapped while being hand tightened. Once all issues were corrected it adds a nice deep sound to the engine. Had good luck with K&N in the past but would not purchase again.