Mount-It! Ceiling Projector Mount Low Profile | Universal Mounting Bracket | 30 Lbs Capacity (Short)

The instructions were clear and easy to follow. More than enough hardware for mounting my projector. I likes that there was space to hide my wires within the down tube.

Came on time, easy to assemble and install. Plenty of extra screws, bolts and washers, you'll have all you need!

This mount is exactly what our church needed. It works well.

This is a good mount, and gives you a lot of freedom to move the projector around. The majority of the assembly is straight forward, until you get to the part in between the long arm and the spider that attaches to the projector. Why on earth they didn't thread where the screws go into the long arm at this point I can't imagine. It makes for a tough assembly at that point - the rest is easy. If this one thing were changed I could give this 5 stars, but it is such an unnecessarily inept design failure that it deserves 1 star off. Great mount otherwise!

It's a barebones mount. It came to do a job, and be as flexible as possible given it's price. Does it do it??? Oh yes, it does. This cheap mount will easily hold your 800 dollar projector, and it's fully worth the price. Don't concern yourself with spending tons more on some fancy mount. This one will do the trick, and you can use the money you saved to take your wife/husband/cat out for dinner.My only advice. make sure you purchase a HDMI/POWER cable long enough. I'm 0/2.

This does not have an easy quick disconnect as described, it still requires an Allen wrench and modest effort.

Excellent product would recommend to anyone who's looking for a good projector mount. It moves up and down and side to side.

Works great installed easy. Shipping took a lil longer than expected.

I have an Optoma UHD50 4K projector and this mount was a perfect fit. The only downsides were that I wish the stand had more upper swing. Meaning, the upper pivot point is limited with the degree of motion. To better fit the 100' screen in my theater, I was hoping to better dial in the size by using the mount functionality by swinging it forward a bit more. The other issue was the horrible engineering in setting up the pivot points with plastic washers. It was very awkward once the mount was hung to place and tighten the screws and plastic washers. At one point I had to tighten the screws down and the pressure broke the plastic washers (poor design). Other than that, the mount serves its purpose and does an "OK" job holding the projector in place.

Has to many bolts for adjustment. When you tighten them the projector moves. Then when they are snugged down it will moves in that joint. Got it to work though.