Ocean Kayak Scupper Valves M Pack of 2

Installed these scupper valves in rear holes of a Sportsman 106. Fit was tight but not obnoxious to install. Water doesn't come in, it does drain out.

[This review was collected as part of a promotion.] These scupper valves work great! I recently purchased an Old Town Sportsman 106 PDL and wanted to eliminate some of the water entry that is common through the scupper holes. I ordered a few short, a few long, since the 106 PDL has some varying scupper hole dimensions. The kayak remains dry and valves fit well.

[This review was collected as part of a promotion.] These scupper valves work great. I tested them in my sink prior to installing. They're well made and fit in my Oldtown Autopilot 120 perfectly.

[This review was collected as part of a promotion.] they scup very well,scupper nog scup that water right outta here

[This review was collected as part of a promotion.] Works as advertised. Drains water easily, my yak is dry.

Ok fit. The larger one fits perfectly and the smaller ones fit the aft storage area and battery box well just fine. The other 4 in the forward foot well needed to be modified to fit properly. I had to remove the o ring and trim down the groove it sits in with a rat tail file. About 5 minutes of material removal and then reinstall the o ring and it then inserted with a snug and proper fit.

Tight seal for my bigwater 132 PDL Does as intended

These are a great fit, and they work very well with my Bigwater 132.

Great product fits great in my old town kayak. Water goes out doesn't come in.

They are mostly alright. I have an Ocean Kayak Prowler 13 Angler. I installed these in seat scuppers and the storage area. I've had it out on 3 12 hour trips now and while the water in the seat is reduced considerably, water does still backflow in. I've tried adjusting the fit after each trip and no change. Hopefully I can figure out the issue, but I feel like they shouldn't be so finicky.