Rough Country Lower Windshield Light Brackets for 07-18 Jeep Wrangler JK - 6004 Fits select: 2008,2015-2018 JEEP WRANGLER UNLIMITED

Really like the fact that Rough Country ships their products out super fast. The 6 inch lights are actually brighter than I thought they would be. They bright up really far too. Definitely worth the money. Also seems to be really nice quality. I'm planning on mounting them to my trucks rear bumper. Would highly recommend.

Installed in my Tundra and I am very happy with the MLC-6 switch controller. This product is built with very high quality parts and design. The beauty of this product is its simplicity and completeness. There are other controllers out there that have soft-touch buttons etc, but this product uses tried and true rocker switches… This product will just work!

Kit provides everything you need and more. I have an early 2007 and the middle footman loop was riveted to the windshield which the kit provides replacements. I opted to use rivet nuts since I already have the tool. I also liked the fact they provided the parts for the direct power source option. Instructions were clear and straightforward. Be sure and watch the instructional video by @AdventureDex.

This mount looks great and adds a rugged look to your Wrangler. If you have an older Jeep, be prepared to have the internal nuts on the mount bolts snap due to rust, which requires a lot of work to replace. It creates a lot of wind noise, but that's to be expected with a light bar.

For starters, this is a nice and sturdy product. It was easy to install and bolts up really well and looks level and center in the bumper. The only reason I am giving this mount 4 stars is that the measurements are inaccurate. It claims to be a 20” bracket but I ordered a lightbar from another company that was 22. 7” and i still had to use washers to space it out properly so I could tighten the lightbar down. You can use a 22” lightbar if you choose.

We have had the system for about three years and it worked great but recently had intermittent issues with the system. I wanted to purchase a new control board but the only way to get it was to buy the new system. Hopefully this control panel holds up a while since that is all I replaced. I guess I have back up wiring and switches. I would have given 5 stars if I could have ordered replacement components.

Cost of kit with brackets are good value , only problem is getting the hardware reinstalled in windshield frame when securing brackets . You can't get good access with a tool to tighten top bolts. Had to get creative… RC could modify this bracket with a notch for JK's to make install much easier.

I would give 5 stars all went well except instructions do not give clear instructions, my husband installed and the light switch stayed on and installation should state to hook to fog lights

I purchased thinking it would fit my 2024 Bronco Badlands. Because bracket was to tall to fit without making contact with hood insulation. So I had to modify the bracket by lowering the bracket 3/8" and rebent the bracket 3/8". This provided enough clearance to allow the hood to close without pushing up the hood. I believe someone should redesign a bracket just for the Bronco or can be relocated to allow for proper clearance.

Good quality, but had to bend and pull and move them around to get them to fit just right for my light bar to go in my grill straight. Wasn't just a bolt up and fit perfectly. But I did make them finally fit.