I bought a 20ft x 54in Coleman pool. The cover that came with it was an absolute nightmare to put on and get it to stay on. It just barely fit over the edges. This cover is infinitely better. With the help of the pool floats, I can install this one easily by myself if needed. But yeah, with two people it slips right on and goes WAY down the side of the pool so you know it is secure and not going to blow off. Even without the cable tie system the wind would have a hard time blowing this cover off. I read reviews saying the cable latching mechanism is difficult. You've just got to be smarter than the inanimate object you're working with. Put the cover on, run the cable through the loops, starting where you want the winch assembly. Once you get it all the way around tie off the long end to the non-winch side of the cable. Leave 6inches to 1 foot of cable on the winch side. Cut off the remainder of the cable that you tied off and discard. (or leave it on there if you don't have anything to cut it with) Feed the shorter end through the hole and into the winch. Turn the handle until it is snug and you are done. To release, turn the handle in the tightening direction until you see the release lever lift slightly. Then push the release lever and pull the winch back towards you. (Pro tip, don't let the little wing nut winch lever smack your fingernail. It is not a nice feeling.) 10/10 would buy this cover again.