Speedway Motors Adjustable Sprint/Midget Car Chassis Stands: Portable, Sturdy, Locking Rubber Casters, Non-Slip Rubber Mounts, Adjustable Height (16-20 Inches), Sold in Pairs

Having but a small 2-car garage, I was stuck for space. On one side I was restoring an old MG. The other side held the chassis and body of a recently purchased Factory Five Cobra Daytona Coupe. I needed to be able to shuffle the cars around in order to work on them. The MG was the easier. It was sitting on car skates, but the Daytona was just a bare chassis and body sitting on jackstands. Then I saw these rolling stands for Midget Race Cars and thought, 'I wonder?' They were 30 inches wide and the bottom of the Daytona frame measured 24 inches. So I took a chance and ordered them. The Daytona fit perfectly. Moreover, the casters allow me to move the chassis easily, and the locks on the casters hold the car solidly in place when working on the chassis.

This actually the second set of Speedways stands I've purchased. Both exceeded expectations.

Makes rolling chassis around very easy

excellent service

Good quality product

I ordered one to try out here in our shop, good stuff works well. Can't make it myself for the price. Went together easily. Ordered 2 more. 3rd one had issues on assembly. Combination of a tubes interior seam weld and too much powder coat on the corresponding legs meant a half hour lost to sanding the interior of one tube and the exterior powder coat of the other. Just to get it together. It's no longer as pretty as the others but it works

The get the nut on the wheel stud is difficult if they would have just 45 the cut on the tube been easier to install and tighten nut other than that works great

Bought them to use on micro sprint car. A little to wide for that application but overall a good product

The fabrication of the stands was lacking in quality. Need some work to assemble as a result but, do work as intended. Puts chassis at a nice height