SwitchBot Motion Sensor, Smart PIR with Stand, White

I use it to control my heat-pump, I automated the start and stop using the thermostat, sometime the bot just don't press the button. I have a hub near the button. If you need it to open light/close light it will work fine, IF the light does not open, just repeat the operation, but with an heat-pump, without human intervention, this is not 100% reliable.

Got a motion sensor for one of my balconies and it's connected to a bot which is attached to an emergency bell which is located downstairs ( for my mom's use) Works as intended. I can schedule the bot to only press the bell on a daily schedule (at night). I also like the fact that the motion sensor runs on 2 AAA batteries. No wiring needed. Good job!

I use this Motion Sensor with The Swithbot curtain inside a cupbord on the closet rod. Why ? Whith a string and elastic between my room door and the cupbord I make a automatic door ... for my cat ! Fantastic :)

Overall it is doing what I need it to do extremely happy. It seems a bit slowy sending a signal but that may be because it's currently using Bluetooth not internet, need to buy more

The motion sensor is great, it has been used for turning on lights and turning them off when motion is not detected.

Works well, both day and night, it always sees me and also perfectly synced with IFTTT! would totally reccomend.

Works really well with no issues

The device works fine, but it is absolutely necessary to know the time of the last motion detection (like "lastDetection", as an example) through the SwitchBotAPI -> Get device status. moveDetected is not enough. Please, add it as soon as possible! Thanks in advance!

It s small, light and works with battery, but the sensibility isn t so high to detect people and if i use it to turn on the lights when i enter in the room, it takes about 6 seconds.. it s a bit too much

It works nicely, maybe the motion sensor is not always spot on and does not always see a person entering the room. But when I set the scene “if motion is detected, turn on the light”, it might take anything between 6 and 10 seconds to switch light on. And the hub is very close by,. So here definitely there is something to work on, speed is critical