Walnut Hollow Non-Slip Hot Knife Blades, 4 pieces

This hot knife did exactly what I needed it to!!!!! I had to make masks out of rubber mats and it cut thru the rubber so smoothly. I loved it!!

Awesome product for what I needed! Used it to cut out a template for installing a cabin air filter on a 2014 Ram 1500. Using a Dremel would have put plastic bits in my air ducts; nobody wants that. Using a utility knife would have taken WAY to long. This made the project easy, fast, and with professional results.

My goal for this knife was to cut a foam backing around a rubber art stamp. I have removed the red rubber from wood backed rubber stamps and placed the red rubber on a specific type of foam. I tried cutting around the red rubber and through the foam but it was so sticky I had to find another method. The hot knife was recommended. The knife cuts through the foam like it was butter. It cuts around intricut corners with amazing ease. I am very thankful for this tool. Read the directions and follow them. It is very safe for an adult if you pay attention to the directions.

Great hot knife. Used it to cut and melt sailing lines. Halyards, sheets. Double and single braided lines, including decron poly and dyneema.

It cut through a hard plastic bin easily. I highly recommend this product!

This hot knife was the best I have used and I use them to cut holes to install car stereos. It works great on plastic!

Just what I am looking for to use with my art projects.

This wasn't exactly what I was looking for. It did not come with a long bar to be able to cut more than an inch deep. Just came with two 1 inch blades.

hot small blade- but stays hot untill you turn it off - it will cut thru hard plastic slowly

I purchased 5/8" Foam board to cut into 8" x 16" pieces to seal off foundation vents. The blades furnished did not cut deep enough and left a broad cut mark at the top of the cut. I used a hand box cutting tool to square off the pieces All in all the job came out fine. Especially since foam board is quite flexible.