Watco One Step Paint & Poly Remover-351926, Quart

I was surprised to find this product at the Walmart near me. We have 3 stores near us, but the store closest to me isn't as nice or stocked as the others. Great product!

this product is easier to use than most. it does what it says and removes several layers at once. it makes the job less strenuous. its my new go-to

I wanted a product to remove some paint spray and spots on my aluminium tire rims after doing some touchup painting to my older car but found that not only does this stuff rather easily remove metallic spray paint, it also removed many years of stains and corrosive junk from my rims as well without damage to them. I used a simple sponge scrubber from my kitchen to apply the stuff and watched the paint and crud dissolve within a minute. I then rinsed off the rims with water and redid the areas I missed to see my rims which looked like new. I was once quoted $25 a rim to fix this corrosion. But, be careful, since this is powerful stuff, so wear proper gloves and a mask. Protect your eyes! It will eat through the sponge part of the scrubber but the heavy-duty scrubber part worked fine for all four tires. Do not get the stuff on your tires, just the metal rims. It will harm rubber. Traditional car rim cleaners were a waste of money for me.

Okay I got this a few months ago and wanted to wait to write my review. I tried it on different surfaces multiple times. It lasts most 5 days if not 2 and then falls. It's a waste of money if you need it long term.

Product instructions state leave on 15-20 minutes. I had to leave on for 30-45 minutes to be able to remove small amounts of old stain. Will not be recommending this product

I coated the table and waited 30 minutes and with all my strength stripped the paint painstakingly. it was hard. I see others just push the putty knife and strip stuff so easy. not with this stuff. maybe being 104 degrees had something to do with it. my goodness stripping thick paint is hard.

Didn't work very well at all on very old lacquer on a brass, silver plated trumpet someone had lacquered with gold tint lacquer. I even left it on much longer than instructions. And it was a mess to remove with cold water and got everywhere causing me to have to clean all the tubes and then started making white patches on the silver so I had to meticulously wipe down with acetone. What a pain. Have to try something else on next one. All this EPA stuff has ruined every cleaner/remover/de-greaser on the market. Last time I used a paint remover years ago, the paint bubbled up and slid off, no problem.

The Watco One Step Paint %26 Poly Remover was a disappointment. It did not remove the paint and poly in 30 minutes, not even after 2 hours and multiple coats.

the old watco stripper was much better. it takes twice as much product and three times the effort to get what the former product did in one application

Did not remove paint spots. Would like a refund.