Woods 0165 Brooder Lamp with Bulb Guard,10.5 Inch Reflector and 6 Foot Cord (250 Watt, 18/2 SJTW)

dies not come with a bulb was exactly what I needed with 8 brooders of baby birds

I use these to keep my pet warm in the garage works great

It tastes wonderful cooked with pinto beans.

Worked well for my chicks

Worked great

This is a very nice chicken run. Easy to move around in my yard. I did add two 10' pieces of EMT 1/2" tubing to the bottom on the long sides to make it stiffer. The doors have a latch but I did add the double S clips enclosed for safety. I did not want my chickens to get out. The wire on the cage is like the wire on a dog kennel. I am very pleased with the cage and my five chickens like it too. Now for the assembly: It comes in five sections, two ends, two sides that attach to the ends, and one middle side. Make sure that when you attach the end to the end side that you don't turn it the wrong way because you won't have the clips you need to attach it to the middle section. Also make sure all the doors open to the outside. When you attach the ends attach the bottom clips first and then the top clips. This makes it easier. Then attach the rod that goes across for support and one end is finished. Do the other end the same way. When you attach the middle section; attach the top sections first. These are the hard ones to connect and with the bottoms loose you can move them around so they will connect. Then connect the bottoms which can also be slid around. Your cage is complete all you need to do is apply the zip ties to stop it from separating. It helps to have someone to hold the sections up wile you connect them. It wasn't that bad; you just have to figure out where the pieces go. It would be easier if they marked the three side pieces: 1,2,3 or A,B,C and outer end / inside end. And the middle section left side, right side. Or Or red dots on the end and the first section, blue dots on the first section and the middle section. green dots on the middle section and the other end. I bought a second one and it was much easier to put together.

Good but too bad it doesn't have a clamp

Came bent. No on off switch. It feels like thin aluminum.

Metal shield is very delicate and easily dents. My order arrived all banged up.

The bulbs never showed up yet and both lamps came squashed these pictures are after I had bent it out most of the crushing part of it.