3GRACE 20 Amp GFCI Outlet, Tamper-Resistant Receptacle with LED Indicator, Self-Test, Decorator Wall Plates and Screws Included, UL Listed, White (1 Pack)

impressive replacing this ease of setup. amazingly simple organizing the colors. great instructions done it before so you know it wasn't that hard. anyone can do it. make sure you turn off the power to the receptacle before you decide to start taking it apart. otherwise you will have a shocking experience

I have a shop and there was no GFCI proterction, whis I needed a GFCI at the shop in all receptacles. Since i installed the GFCI in line with all the other receptacles, I protected the all with this one GFCI. Also Amazon had the best price available..Thank you

installed in basement near water tank for a space heater. tested and works great. Helpful Tip: wires in need to go closest to ground screw. wires out to next outlet/etc attach to other end. otherwise it wont work. when installed correctly, no green or red led should be lit, and you push the reset button to power it up, green led should then be lit.

I've purchased two so far, 👍 One for the kitchen, one for the bathroom. Thinking of a couple of more; one for the basement, one for the outside recepticals. The self test features are great, and they seem to work flawlessly. I'm both impressed and satisfied.

They work as good as the 30 GFCI plugs

Very good GFC have not taken it out the box yet, but bought in the past good price good quality

Casing is so big that it takes up almost the whole box and thus is difficult to install without crushing the wires.

for a 20 amp outlet you have to remove the screws to attach 12 gauge wire. then its a matter of luck to get the loose internal nuts to bite again. took 20 minutes to install 1 simple outlet. all i was doing was replacing a 15 amp with this 20. not worth the hassle and frustration

Ground screw has no stop and no way to put it back... caution should be maintained.

piece of junk need to get regind