Eastwood Rust Encapsulator Plus Paint Pint

Easy to apply and it coats extremely well. Time will tell the real story on my boat trailer used in saltwater service but so far, I really like the product and plan to purchase some more for my iron hand rails on my home that I'm having to repaint due to rust.

Very good paint

Great product. It helped me restore my rusted Minnesota work van and give it years more of service in my business. Combine this product with proper surface preparation and you are going to be satisfied and feel accomplished. I used a flap disc on rusted areas and did a couple coats of this stuff with a brush, followed by paint. This product levels well with brush application.

I can't say how long it'll hold up, but it went on well and cured just fine. Messy and smelly, but of course it is.

Difficult to clean up drips and drops. Seems to work as advertised.

Yes, finally got to use my four cans of the internal frame coating plus on my vehicle! I also hand the 24” special nozzles too! The weather here was just too hot to do this for the last few months! Yesterday the weather was great, and very decent for the next few days. But today, I used my four cans to coat my 2021 Nissan Frontier frame to the best of my ability! My biggest issue were the 24” spray tubes that wanted to come off while spraying! You really need a more aggressive tube system that is held tightly to the can. Maybe a trigger style would work. Work was completed in a few short hours.

I thought I was getting a quart at the price I paid. I got a pint.

5 days late because you use FedEx and they can't deliver in a dependable to 04853 %26 04863.

My first time using so I carefully followed the instructions on the can and used mineral spirits to pre-clean. The next day I coated the firewall and the paint crinkled a few minutes later. I called tech and they said I should have used Acetone to avoid a chemical reaction. I had to scrape and sand and recoat.They need to change the label!!

I had nothing but problems with this stuff. I was using the long tube on the nozzle and it would occasionally spray out from the nozzle making a big mess. If you paused for more than a minute, the tube would clog up and the spray would either stop or leak out the nozzle. I have several large 1-1/2” dia access holes in my frame. I taped them over and used the spray. When I took the tape off, there was no spray on the inside of any of them beside what looked like a tiny bit of overstay. Also, out of three cans, I didn't get to completely empty any of them because the cans would stop spraying. I assume they were getting plugged. Bottom line, I would not buy this product again.