Hyper Tough 1200 Lumen 24" LED Slim Under Cabinet Light, Linkable

for the price it's awesome! lot brighter than I thought it was going to be with a good coverage amount of light assembles very easily very easy to hang. all you need to fill a head screwdriver and a little bit of tape Mark your holes put it on the wall bam all done! very sturdy built aluminum and takes up very little room

I bought two of the 2 packs, which was cheaper than buying 4 individual ones. I used them to replace old fluorescent under cabinet units. I would have preferred direct-wired units, instead of the plug-in type. I have heavy gauge wires coming from the wall and controlled by a switch. I did not want to cut the thin power cord of these new LED units, so I connected the wall wires (White, black and ground) to a 2-receptacle outlet which I placed in a covered J-box and plugged the new unit into the newly created outlet. I kept the rotary switch of the unit on, as they are now controlled by a wall switch. The emitted light itself is pretty bright. I did not interconnect the units, as a single 24" unit was adequate for my intended result. The units are very light and thin, and not heavy duty/industrial quality, and I don't think the LED inside it is accessible for replacement. So, if it dies, I will probably throw it and get a new unit. I did not need the included connector wire which is ridiculously too short (just a tad over 7"), specially to have two 24" lights that close. Ideally it should have been at least 2 or 3 times longer to be of any meaningful use. Considering the price paid, plus the extra for the outlet, cover and J-box (all 3 for less than $4), no complaint. The cheapest direct-wire LED unit elsewhere (Think the online competitor or the big blue or orange stores) would have cost about twice as much. Recommend, considering the price. Thank you.

I mounted this light below a cabinet in my kitchen because that area was a little too dark for me. This light is very bright, it lights up the area very well and the light it produces is spread perfectly. I've only had it for a few days but I use it for several hours each day and it seems to be working well so far. The price is fair in my opinion.

I love this under cabinet light. I set it up under my kitchen sink upper cabinet for a beautiful look and adds so much more light than the ceiling light. I also like the switch I think it's better than the motion ones because you can just turn it on when ever you want sometimes motion sensor ones lag or don't turn on with no switch to fix the problem. Overall highly recommend this product and the price is icing on the cake.

I love this light! Simply plug it in and mount it that's it. Easy to install and great for adding light to an area that's just to dark. I used mine in the kitchen area under the cabinet.

Nice look. Bright enough for medium sized areas. Comes with two cords, one to connect to 110v (with a switch) and a second cord to connect to another light (for stinging lights together). I will note that the dimensions of the light are accurate but you also need to consider the plug that goes into the light for total width which adds another inch to the entire width. It was a little difficult to get the screws close enough to the mounting surface to get the light to be mount tightly. I would prefer a method of tightening screws with light in place instead of tightening screws and sliding light in place.

Could wish the switch was closer to the plug instead of closer to the light (I am using these on TOP of my cupboards, the switch is quite high up), and a rocker instead of a disc switch. Other than that they're fine, and much cheaper than most other plug-in options. I'll likely end up buying a few more to do the rest of the cupboard set.

Mounting these lights on the underside of shelves did not work. They were very glaring and did not shield the light going out, and into the eyes of the viewer. These would be fine if they were used in a visually hidden location, under a cabinet below eye level.

worthless product impossible to install may have to take apart and drill holes of course it's not easy to take apart and you'll probably break it they're screws to screw in and slide it in but they give you no template they just give you a rough pretend measurement template would be nice you might be able to install it the way they think you can in the meantime you'll just put tape on it or take it halfway apart Andrew holes in it and then screw it in or just return it or better off just don't buy it it's pretty much worthless

i ordered a hyper tough light 1300 lumens and it was missing parts. i started an online refund. i ordered a hyper tough 1200 lumens. i went to the store today to drop off the light. then i went to curbside pick up the 1200 and it said it was picked up at 9:50am, that's the time i dropped off the missing parts. chat was no help. i was on the phone on hold for over 20 minutes before i was diconnected. i still haven't gotten any information. if i dont receive any info for pick up i will report it to my credit card company.