Miller Cage J Clips 1lb Bag and/or Pliers Assemble Repair

Works great. I was able to quickly assemble a cage with this product. The clips don't require much force to apply with the special pliers and have held up well to my medium sized rabbit's zoomies.

Not much to say. You order clips and you get clips..

These clips accompanied with the special plier would probably work great, but not withe the heavy gauge wire I was using. Too bad. The pliers and clips worked easily together. The picture of the rabbit should have been a giveaway.

I use them because I need them but hard on my hands

Easy to use does the job

This brand made clips not bent into full-J like J-clips used to be, so seem to only fit their brand tool. But, I finally found out how to make these work in the older, regular J-clip tool I already have: To fit into tool you already have, sit the bended side of the clip up higher, above the curve-slot, and put flat part lower in tool in the curve-slot on the other side. The clip balances there and as you squeeze the tool, it bends the clip into more of a J as you close it. I could not figure it out until I brought my tool into a different store and was shown how it can work on the stronger, usually iron, older tools. (I did not have to buy the lighter tool made for these "right-angle" bended clips.) Otherwise, I could not get these clips to work in my tool at all, and I thought I would have to bend each clip individually with pliers to make them fit into my tool. Just balance the clip, it holds there in the tool above the slot, and once under pressure falls down into the slot like the better clips we uses to buy that were already bent into a fully-curved J. Then, these clips can be put around the cage's wires like normal. Clips NOT bent into a big-curved J do not fit in my tool THE SAME as ones bended more--but they still can work and do not need to be bent more, individually.