SHAKESPEARE E-Z Loader Universal Fit Replacement Bump Feed String Trimmer Head (1 Count)

I like that the part that you bump on the ground to feed the string has a separate spinning part that contacts the ground and doesn't get worn out as it isn't spinning with the rest of the head, while feeding the string. Also, it feeds the string much easier than the original manufacturers bump feed head.

I looked this over and decided to take a chance on the fit to my Kobalt 24 volt Weed Eater even though it was not listed for use on it and though I was able to use some parts they are not a factory fit so keep in this in mind when you research the applications for this part to save yourself a lot of time and effort with negative results.. I took a chance and lost, my own fault.

This item was purchased to replace the OEM Hyper Tough weed eater head after searching for that particular item decided on the Shakespeare after watching videos showing that it would work for the Hyper Tough head. It was a bit challenging, but perseverance paid off.

I have purchased this item for a number of trimmers. Works as advertised, and have had these for years . None has failed yet, and don`t expect it any time soon.

Purchased to replace Walmart HyperTough trimmer head. Worked great. Had slight problem and called customer support line. Wonderful lady Monica talked me through it and was very knowledgeable. Recommend highly.

was fast shipping, i installed, took a minute to figure out which adaptors to use on my brand of weedeater. once I got it installed it worked great. better than the original head. i also like that you can wind the trimmer line onto it. only thing that would be better is if it wound on by spring loading/self winding. lol. I took me little longer to figure out how you load it. why I didn't give 5 stars

This was easy enough to use. Unfortunately, it did not fit our weed eater. That is my error, though, as I did not read the description closely enough. Be sure to check the compatibility list.

Bought this for kobalt 40 v weed eater. Instructions said it would not fit. It fit perfect except I had to use original hex nut nuts that came with it would not work Works better than the kobalt head

It will not work with Craftsman Model 154.74092 as shipped. The adapters are correct for a reverse threaded bolt but these Craftsman weed Wackers are not. I was able to modify (cut in half and drill out the center) of the adapter, needed to buy a regular threaded nut to get it to work.

Bought this replacement and put on my craftsman, used once short time and now it is stuck and burrowed onto the shaft. The whole shaft has to be replaced now