PAC RadioPro RP5-GM11 Radio Replacement Interface With Built-In OnStar Retention, Steering Wheel Control Retention and Nav Outputs for Select GM Vehicles

wired up like it should, only issue is it was tight to get it all pushed back into the dash so that the radio would mount correctly. couple of the wire being a little longer would have made the job much easier. my son is not one to read the instructions so when it didn't work as it should I read the instructions and you have to set the dial to the radio you are installing so the controls will all work, and you have to do that before you power it up.

Great fit for my 03 bose/onstar equipped Tahoe. It kept all the factory steering controls and worked with the factory amp.

Please be careful when you purchase a car stereo , there's more to buy, finally got the right interface after 4th time ordering, Tech support doesn't know which one either. But now stereo sounds great.... Thanks

It seems to work fine the only problem was the directions use Pioneer stereo it says you can use the jack for the remote but I also had to use the blue wires that say there for other radio connectors to get the audio to work

Works good got my swc working

the programing sucked. It would connect and disconnect on its own

easy enough ro hook up however did not operate steering controls as described actually no key operations.

Tried calling seller for a week leaving messages with no response. Bought a PAC RP5-GM11 that would not power up. Was able to troubleshoot with PAC online support to determine it was defective. Sent email and still no response. Might change rating if I can get help

plugged in and prong broke off

doesnt fit truck