Rust Bullet Automotive - Metallic Gray - Quart - Rust Inhibitor & Protective Coating for Cars, Trucks, & Metal Surfaces, UV Resistant, No Topcoat Needed

I have a car that is eighteen years old, and it started to develop a little rust behind the wheel wells, so I had to sand it down and repair it with body filler. When that happens, the metal gets pitted. The rust works its way into little pinholes. I thought I would need to remove all the rust so that the problem wouldn't come back in a few years, but a friend told me I could paint over the pinholes with this product instead, because it neutralizes the rust. That allowed me to preserve a lot more of the metal, so the repair was much easier and the result was better. I did some reading on the Internet and learned that I could use Bondo right over the top of the paint. So far it has worked well. Now I am using the rest of the Rust Bullet to touch up other rusty metal around my property. I have used outdoor house paint over the top of it, and that worked well too. The product is expensive, but I'm finding that a little goes a long way.

I used this Rust Bullet paint on my car's frame and it worked amazingly well. The application was smooth, it dried quickly, and the metallic gray finish looks great. Most importantly, it sealed the metal and stopped rust from spreading. Highly recommend for anyone wanting long-lasting rust protection.

I read the application directions online at rustbullet.com to be sure I applied it correctly. The 1/4 pint can is too small to adequately print the instructions. The directions said to stir thoroughly for approximately 3 minutes until it was "completely uniform and homogenous." I did this but it immediately has some elements that collect on the surface. I am hoping that this does not make a difference. It goes on beautifully and dries to a very nice looking finish. I waited 2 hours before applying the required 2nd coat with the same product. Since my car rust was underneath the fuel door and not visible, I did not need a color shell paint for the second coat. Cosmetically, the result was very good. Now I hope that it can stop the rust.

Paint is thin enough to spray using hvlp sprayer. What i like most about this paint is the very little prep needed for adhesion. I did apply 2 coats, per instructions, and although it took half day for it to dry, it is holding up to multiple constant rain. My next project for this is painting the galvanized chimney cap.

This stuff really seals out the rust! You can paint right over it with minimal preparation and so far so good!

My son-in -Law was. Able to repair my car with this product %26 2 other products!

Does the job as good as any product. Fair value for the money.

Completely encapsulated the rust completely encapsulated the rust very impressive

I didn't expect to have so much trouble opening the can. Put some on my truck around the rockers and fenders of the truck and it actually blended in with the silver paint better than expected. Time will tell how well it works.

Product came on time and install went as expected. It worked well with the the bondo fiberglass mesh for fixing holes. It is slightly thicker viscosity than "miracle paint", which made it easier to install the mesh right away after applying a first coat of the paint. . . no need to wait for it to start to cure and get "sticky" before applying the mesh. Now we wait to see how long it stops the rust. :)